24
2)
Open the cover screen and remove the grease filters (as
previously described).
3)
Position the cooker hood against the wall and mark out the
position of the three screw holes in the wall bracket.
IMPORTANT: The wall bracket needs to be located at a
sufficient height to allow the minimum clearance distance
stipulated on page 23.
4)
For the sloped cooker hood models only (BESW601,
BESW901 and BESW902) you must also mark out the
position of the anchoring points on the rear of the appliance.
5)
Remove the cooker hood from the wall and place it on a
cushioned surface.
6)
Using a drill bit with an 8 mm diametre, make three holes in
the wall on the positions that you have marked in step 3 (for
the wall bracket).
7)
For the sloped cooker hood models only, using a drill bit with
an 8 mm diameter, make 4 holes in the wall on the positions
that you have marked in step 4 (for the anchoring points).