Baumatic BE60GL, Instruction Manual, Page: 17 / 32

Installing your cooker hood
IMPORTANT: YOU WILL HAVE TO DECIDE BEFORE
INSTALLING YOUR COOKER HOOD WHETHER TO USE
IT IN EXTRACTION MODE OR RECIRCULATION
MODE. PLEASE TURN TO PAGE 24 NOW TO
UNDERSTAND THE DIFFERENCES BETWEEN THESE
TWO MODES.
o
We recommend that at least two people install this hood.
o
If you are using the appliance in recirculation mode, then
PLEASE NOTE that all of the vent in the upper chimney section
must be exposed. You will have to take this into account when
calculating the minimum height of the extractor when installed.
o
IMPORTANT: If the recirculation vents are obstructed the
efficiency of the extraction will be affected and could
damage the motor.
IMPORTANT: YOUR COOKER HOOD SHOULD BE CONNECTED TO
YOUR MAINS SUPPLY AFTER THE REST OF THE INSTALLATION
PROCESS HAS BEEN COMPLETED.
17
1) Remove the metal grease filter.
2) Position the hood against the wall that you are intending to
install it on and mark the position of the support holes that are
to be drilled (as shown in the figure above).