o
After the programme has finished, please follow the Maintenance
and Cleaning instructions to clean the appliance, lint filter and air
condenser.
Error code failure system
If your appliance senses that it is not operating correctly, then an error
code may appear on the LED display.
BEFORE COMPLETING ANY MAINTAINEANCE ON THE
APPLIANCE, IT SHOULD BE DISCONNECTED FROM YOUR
POWER SUPPLY.
Error
code
Possible causes
Solutions
Flashing
o
Container drawer is full of
water.
o
Pump error.
o
Empty and clean the
container drawer.
o
Check the pump.
Flashing
o
Lint filter is full and blocking
the air flow.
o
Empty and clean the lint
filter.
E30
o
Heater issue.
o
Check the heater and
thermostat.
o
Call the Service
Department for assistance.
E32
o
Humidity sensor error.
o
Check humidity sensor and
PCB.
o
Call the Service
Department for assistance.
E33
o
Temperature sensor error.
o
Check the front
temperature sensor.
o
Call the Service
Department for assistance.
E34
o
Temperature sensor error.
o
Check the rear temperature
sensor.
o
Call the Service
Department for assistance.
E60
o
Motor error.
o
Check the motor and the
PCB.
o
Call the Service
Department for assistance.
If a fault code reappears after following the above
advice and clearing the fault code. You should
disconnect the appliance from your mains supply.
Then arrange for an engineer to attend the
appliance. You should contact the Service
Department on 1800 444 357.
22
