33
Electrical c
ordance with the latest edition of the
I.E.E. Regulations and in compliance with Baumatic’s
g the appliance, make sure that the supply
voltage marked on the rating plate corresponds with your mains
cent to the
appliance, preferably above worktop level. An outlet can then be
located at the rear of the appliance for connection.
nnection, securing the cord in place with the
cable clamp provided and then immediately close the terminal
change the oven power cord, the earthing
(yellow/green) conductor must always be 10 mm longer than the
o
Care must be taken to ensure that the temperature of the mains
maged, then it must be replaced
by an appropriate replacement which can be obtained from the
o
Cable type: H05 RRF 3 core x 1.5 mm³
onnection
This appliance must be installed by a qualified
person in acc
instructions.
WARNING: THIS APPLIANCE MUST BE EARTHED.
o
Before connectin
supply voltage.
o
This appliance should be wired into a 13A double pole switched
fused spur outlet, having 3 mm contact separation. This should
be placed in an easily accessible position adja
o
To connect the oven power cord, loosen and remove the cover
on the terminal block, in order to gain access to the contacts
inside. Make the co
block cover again.
o
If you have to
line conductors.
supply cable does not exceed 50°C.
o
If the mains supply cable is da
Baumatic Spares Department.
