Baumatic BACG3034, Instruction Manual, Page: 16 / 23

AS/NZS 1869 (AGA Approved),
10mm ID, class B or D, no more than 1.2m long and in accordance with
AS5601. Ensure that the Hose does not come into contact with the hot
surfaces of the hotplate, oven, dishwasher or other appliance that may be
installed underneath or next to the hotplate. WARNING: Ensure that the
hose assembly is restrained from accidental contact with the flue or flue
outlet of an under bench oven. The hose should not be subjected to
abrasion, kinking or permanent deformation and should be able to be
inspected along its entire length. Unions compatible with the hose fittings
must be used and connections tested for gas leaks. The supply connection
point shall be accessible with the appliance installed.
Before Leaving
- Check all connections for gas leaks with soap and water.
DO NOT use a naked flame for detecting leaks. Ignite all burners
individually and in combination, to ensure correct operation of gas valves,
burners and ignition. Turn gas taps to low flame position and observe
stability of the flame. When satisfied with the hotplate, please instruct the
user on the correct method of operation. In case the appliance fails to
operate correctly after all checks have been carried out, refer to the
authorised service provider in your area.
GAS CONVERSION
The appliance as supplied is for use with Natural Gas, if it is to be adapted
for Universal LPG proceed as follows:
• Isolate the appliance from the electricity and gas supplies.
• If the appliance was previously installed for use with Natural Gas, remove
the NG regulator and replace it with the Test Point Assembly. A gas
regulator suitable for a supply pressure of 2.75kPa should be part of the
gas tank supply.
• Remove the pan supports and burner assemblies.
• Replace the injectors with the alternative type supplied Figure 3 below.
• Use the appropriate thread sealant and check for gas soundness.
• Replace the Natural Gas label with the Universal LPG label located next to
15