18
marked in the diagram opposite and
once established ALL terminal screws
should recheck that the terminal
screws are all fully tightened
he Baumatic
Customer Care Department.
o
o
he cable can be looped if necessary, but make sure that is not
b is in position. Care must be
taken to avoid the cable being in contact with hot parts of the
s supply cable
nt which can be obtained from the Baumatic
pares Department.
mains supply cable should be replaced in accordance with the
itch.
o
Unscrew the terminal screws fixing the cable.
o
ce
with the specification given above.
minal
o
The brass links must be positioned as
must be tightened down firmly.
o
If when the hob is first switched on,
only two of the zones work, you
between the links. This should be
done before contacting t
IMPORTANT: The appliance must NOT be connected to the
mains supply by means of a 13A plug and socket.
T
kinked or trapped when the ho
appliance.
Replacing the main
If the mains supply cable is damaged, then it must be replaced by an
appropriate replaceme
S
h
T e
following instructions:
o
Switch the appliance off at the control sw
o
Open the terminal block on the underside of the hob.
Replace the cable with one of the same length and in accordan
o
The “green-yellow” earth wire must be connected to the ter
marked
. It must be about 10 mm longer than the live and
neutral wires.
o
he “blue” neutral wire must be connected to the terminal
be connected to the
terminal marked with letter (L).
T
marked with letter (N) - the live wire must
