Baumann Mira Isola, Use And Installation Manual, Page: 14 / 32

14
es
14
en
of the instructions included in this manual.
INSTALLATION
The hood may be in filtering or in ducting
version (see A-B pag.2). Decide from the
outset which type is to be installed. For
better efficiency, we recommend installing
the hood in the ducting version (if possible).
FILTERING VERSION (A)
In order to transform your cooker
hood from the exhaust version
to the re-circulating version, ask
your local retailer for active carbon
filters and then carry out the
following instructions.
The filters must be applied to
the suction kit located inside the
cooker hood (fig. 4).
The air is replaced in the
environment via the eyelets
impressed on the connector.
the upper flue must have the air
evacuation slots positioned in the
upper part.
DUCTING VERSION (B)
The hood purifies the air and
evacuates it to the outside through
an exhaust duct or hole (diameter
150 mm).
Roof Venting (B)
AIR VENT
(for ducting versions)
! Prepare the hole and the air vent duct
(150 mm diameter - not provided with the
product).
! Use a duct of the minimum indispensible
length.
! Use a duct with as few elbows as possible
(maximum elbow angle: 90°).
! Avoid drastic changes in the duct cross-
section.
! Use a duct with an as smooth as possible
inside.
! The duct must be made of certified material.
! Do not connect the hood to smoke exhaust
ducts for the products of combustion
(boilers, fireplaces, stoves, etc).
! For the air vents comply with the provisions
laid down by the competent authorities.
In addition, the air must not be evacuated
through a hole in the wall unless specifically
intended for this purpose.
! Fit air intakes in the room to prevent the
hood from creating a negative pressure
in the room (which must not exceed 0.04
mbar); if the hood is used at the same time
as non-electrical equipment (gas-, oil- and
charcoal-fired stoves, etc.) the exhaust gas
may be sucked in by the heat source.
ASSEMBLY
! WARNING:
Very heavy product; hood
handling and installation must be carried out
by at least two persons.
! WARNING:
Wear gloves and goggles when
carrying out installation and maintenance
operations.
! WARNING:
Failure to install the screws
or fixing device in accordance with these
instructions may result in electrical hazards.
!The minimum distance between the
supporting surface for the cooking
equipment on the hob and the lowest part
of the range hood must be not less than 65
cm from electric cookers and 75 cm from
gas or mixed cookers. If the instructions for
installation for the gas hob specify a greater
distance, this must be adhered to.
! Expansion wall plugs are provided to secure
the hood to most types of walls/ceilings.
However, a qualified technician must verify
suitability of the materials in accordance
with the type of wall/ceiling. The wall/ceiling
must be strong enough to take the weight of
the hood. Do not tile, grout or silicone.
! In case of doubt, consult an authorised
service assistance centre or similar qualified
person.
For installation instructions refer to
figures at pag. 2/9