Baumann 440E, Operator'S Manual

Page: 9 / 24

7
SPREADING MATERIAL
REGULATING SPREAD QUANTITY
The spreading quantity is adjusted with the tension adjustment lever. Correct adjustment is
important. If the adjustment is too tight, unnecessary wear of the rubber belts or rotating parts may
occur. If the adjustment is too slack, distribution of material will be uneven.
Hydraulic Units:
All hydraulic units are equipped with hydraulic flow control. To ensure to correct
rate of drop of material, the operator would adjust the tension adjustment lever, hydraulic flow
control, engine RPM, and ground speed. Adjusting engine RPM impacts hydraulic flow.
Electric Units:
To ensure the correct rate of drop of material, the operator would adjust the tension
adjustment lever and ground speed. An optional variable power controller may be installed, allowing
for fine-tuning of the motor rotation speed.
STARTING TO SPREAD
Spreading of material star ts as soon as the tractor’s PTO, hydraulic , or electrical system is engaged.
HYDRAULIC/ELECTRICAL ROUTING INSTRUCTIONS
Electrical: Bauman Manufacturing electric Drop Spreaders include a wiring kit (see page 15 for
schematic). It is the responsibility of the operator to ensure that the motor is wired correctly. It is
important that the direction the distributor drum rotates matches the rotation arrow in
Figure A . A
decal depicting the correct rotation direction has also been positioned near the bearings supporting
these shafts.
Hydraulic: Similarly, the hydraulic spreader models come equipped with the hoses and fittings
already installed in their intended orientation. Ensure the tractor hoses are attached in such a way
that allows for the agitator and distributor drum to rotate in the direction shown in Figure A.
Figure A:
Direction of Drum
Rotation