1. Park tractor and mulcher on a level surface.
2. Lower mulcher to the ground.
3. Shut off engine and remove key.
4. Inspect tooth holders (A) for damage and wear.
Replace individual tooth holders as needed.
5. Remove tooth from tooth holder.
6. Remove mounting hardware on tooth holders.
Install new tooth holder.
7. Install tooth into new tooth holder and tighten
⅜ inch locknut to 65 lb/ft (88 Nm) of torque.
Note
:
Parts breakdown can be found on
Baumalight’s website.
www�baumalight�com
5.8 Replace Tooth Holder
1. Park tractor and mulcher on a level surface.
2. Lower mulcher to the ground.
3. Shut off engine and remove key.
4. Remove plug (A). Oil level should be 2 in. (51
mm) below plug hole. Bend a piece of wire and
insert into hole. Remove wire to check oil level.
Add oil if low.
5. Install plug.
6. To change gearbox oil, remove plug (B) to drain
oil. Dispose of used oil in an environmentally
safe manner. Install plug (B) and fill gearbox
through hole (A) until oil is 2 in. (51 mm) below
plug hole (A).
Note
:
Parts breakdown can be found on
Baumalight’s website.
www�baumalight�com
5.9 Check Gearbox Oil
Level
22
