Baukraft BK-SGC10 SET, User Manual

Page: 19 / 90

19
VI Battery and charger information.
3
3
Store the battery only in dry rooms with an
ambient temperature of +10°C to +30°C.
Place only charged
batteries in storage (charged at least
40%).
Charging a lithium battery.
Remove the battery from the handle, press the button down to do this. Pay attention to the
mains voltage when charging the battery! The mains voltage must correspond to the data on the
nameplate of the charger. Appliances marked with 230V can also be supplied with a voltage of
220V. The green LED will start flashing. Squeeze the battery into the charger.
See explanation table:
If the battery cannot charge, check the following:
• contact voltage
• Makes good contact with the charger contacts
If the battery still cannot be charged, visit an authorized Baukraft Service Center.
To ensure that the lithium-ion battery will last a long time, you must recharge it immediately. You
need to recharge the battery when you notice that the power of the cordless tool decreases.
.Battery capacity indicator.
Press the button on the battery capacity indicator. It shows the state of charge of the battery using 3
LEDs.
All 3 LEDs are lit: The battery is charged
2 LEDs are lit: The battery has enough charge left
1 LED is on: The battery is exhausted, charge the battery
All LEDs flash: The battery is completely discharged and defective. Do not use or charge a defective
battery.
Indicator status Explanation and action
Red LED Green LED Ready to use
The charger is connected
to the mains and is ready
for use; There is no
rechargeable battery in it. “
Not lit. It shines
It shines Not lit. “Loading
The charger charges the
battery “