Operating Manual for
BAUER ECOSTAR 6000
34
5
BUTTON COMBINATIONS
Touchscreen calibration:
In order to recalibrate the touchscreen in an emergency, there is a button that must be pressed and held
while the ECOSTAR is starting.
First the ECOSTAR must be de-energized for about 5 seconds. To do this, unplug the 12-pin plug from the
circuit board for 5 seconds. Then the plug must be reinserted and the
middle of the 5 buttons
on the front
of the ECOSTAR 6000 must be pressed.
The ECOSTAR now starts in the calibration menu. Now press the points on the touchscreen in order (as
instructed on the screen).
The points must be pressed precisely, for example with a pen
Resetting the ECOSTAR:
To completely reset the ECOSTAR to the standard settings, the two outermost buttons on the front of the
ECOSTAR must be pressed at the same time and held for 20 seconds. After 10 seconds, the ECOSTAR will
beep for the first time. After another 5 seconds it will emit a longer beep, and after yet another 5 seconds
an even longer one at another pitch. After the ECOSTAR has beeped for the third time, the ECOSTAR has
been reset to the standard values.
Screenshot:
To take a screenshot of the current display, a USB stick must be inserted into the ECOSTAR 6000 and then
the two buttons 2 and 4 (counting from left to right) must be pressed at the same time..
The ECOSTAR will beep and the screenshot process will be started. If the ECOSTAR beeps again after a few
seconds in the same pitch, the screenshot was successful. If it does not beep the same as the first time, the
screenshot failed.