Page 12
For technical questions, please call 1-888-866-5797.
Item 59365
Sa
Fety
Opera
ti
O
n
Maintenance
Setup
General Operation
1. Make sure that the ON/OFF
Switch is in the
“OFF” position. Insert a fully charged 20 V Bauer
Battery Pack (sold separately) into the Battery
Receptacle, making sure it clicks in place securely.
2. Grip the tool firmly, then push the
ON/OFF Switch forward to start the tool.
For continuous operation depress the front
of the Switch to lock it in the ON position.
3. Allow the tool to come up to full speed
before touching the work material.
4. Apply the Cut‑Off Wheel straight into the work
material using only the edge of the Wheel,
allowing the Tool to operate at full speed.
If the Tool bogs down, use lighter pressure.
WarninG! tO preVent SeriOuS inJury:
Do not grind with the side of the cut-Off
Wheel.
Abrasive cut‑off wheels are intended
for peripheral grinding; side forces applied to
these wheels may cause them to shatter.
5. Avoid contact with foreign objects such as
metal screws and nails when cutting.
6. Do not apply excessive pressure on the
Tool. Allow the Tool to do the work.
note:
Use caution to avoid overheating
the cut‑off wheel. If cutting plastic, cut at
an even pace to avoid melting it.
7. When finished, depress the rear of the ON/OFF
Switch and pull it backward to stop the Tool.
8.
tO preVent acciDentS, aFter uSe:
Turn off the Tool.
WarninG! tO preVent SeriOuS inJury:
allow the tool to come to a complete stop
before setting it down.
Remove the tool’s Battery Pack. Clean, then
store the Tool indoors out of children’s reach.
