32PCM voice multiplexer user manual
22
== Exit, Please input '0' ===
======================================================================
[PDH /Bandwidth config]:
“setl” for setting local equipment,and “setr” for setting remote side.
x,y,z respectively denote hundred's place, decade and unit for a
hundred number; a,b denote decade and unit for a ten number; m means port
number, when m=0 denote optical connector, m=1/2/3/4 denote the
1st/2nd/3rd/4th ethernet port.
If you want to set the 3rd ethernet bandwidth is 55M+32*16K, then input
setl 3 055 16
4.2 Ethernet 10/100M setting, input "2"
[PDH /Config]:2
===================== Port Status Config =======================
== Set Local command : setl x y ===
== Set Remote command: setr x y ===
== Note: x:Port numble(x=1-4) y:0 auto negotiation ===
== 1 fored half duplex and 10BT ===
== 2 fored full duplex and 10BT ===
== 3 fored half duplex and 100BT===
== 4 fored full duplex and 100BT===
== ===
== Exit, Please input '0' ===
================================================================
[PDH /Port Status Config]:
“setl” for setting local equipment ,and “setr” for setting remote side.
4.3 flow control setting
，
input"3"
[PDH /Config]:3
==================== Flow Control Config =====================
== Set Local command : setl x y ===
== Set Remote command: setr x y ===
== Note: x:Port numble(x=1-4) y=0/1;Flowcontrol 0:OFF,1:ON ===
== Exit, Please input '0' ===
==============================================================
[PDH /Port Flow Config]:
