battistella GEA, Instruction And Maintenance

Page: 13 / 18

Gea V.06 12 2018
PROBLEM CAUSE SOLUTION
The items inserted
in the cabinet are
not sanitized and
cleaned (they still
have a bad smell)
An excessive number of
items to be sanitized and
cleaned has been inserted
The items inserted into the
machine must be as far apart as
possible, so that their whole
surface is exposed to the hygienic
action of the ozone
The inserted load has an
excessive bacterial load
(e.g. particularly
malodorous ...) that
requires a particularly
prolonged ozone
exposure
Perform an additional sanitizing
program.
The effectiveness of the sanitizing
and cleaning treatment depends
on the type of garments and the
bacterial load present
There is an accumulation
of dust on lamps and/or
the vacuum grille.
The accumulating dust
progressively reduces the
performance of the machine.
Remove the dust from the lamps
and the grille using a vacuum
cleaner. Pay particular attention
when cleaning the lamps as they
are very fragile. Do not touch the
glass of the lamps with your
fingers so as not to leave
fingerprints and/or fat residues
which could compromise their
durability (fig. 2)
When you open the
door, at the end of
the program, you
will detect a very
intense and pungent
odor of garlic
The ozone blaster does
not function properly Have the correct operation
checked
The door is not
locked during the
execution
of a
program
The door has not been
properly closed
Make sure the door is properly
closed before starting the program
The safety locking of the
door is faulty
Disconnect the machine and have
it checked by a technician
Programs do not
start and the display
shows the message
“ CLOSE THE DOOR ”
The door has not been
properly closed Make sure that the door closes
properly and that the safety
device, located near the door, is
well positioned and secured. If the
message
“ CLOSE THE DOOR ” is
still displayed then the device is
faulty and must be replaced
The machine does
not start or does not
work
The fuses are damaged Check the fuses located inside the
machine (fig. 3). To access the
fuse compartment, remove the top
cover of the machine.
F1= 5x20 - 250V - F 1,25 A
F2= 5x20 - 250V - F 4 A