12
GB
Battipav srl
CAUTION
11
• Adjust the cutting wheel by tightening the
screw with a 3 mm male hexagonal wrench,
until the lateral backlash is reduced, avoiding
any locking.
ADJUSTMENT OF CUTTING CARRIAGE
• Remove any residues from the slide bar of the
cutting carriage, without lubricating.
12
• Eliminate the lateral backlash of the carriage,
by acting on the screw indicated in picture 14,
using a 4 mm hexagonal head wrench.
CAUTION
AN EXCESSIVE ADJUSTMENT WILL DAMAGE THE
GOOD SLIDING OF THE CUTTING CARRIAGE.
CLEANING
Keep the slide bar clean using an all-purpose lubricant
DISPOSAL
In the event of scrapping the entire machine or part
of it, it must be disposed of in accordance with the
methods laid down by current legislation.
Worktable
Aluminium AL
Steel AC
Polyamide PA
Carriage rod
Steel AC
Carriage
Aluminium AL
Polyamide PA
Summary of Contents for 61300E
