Cordless Automatic
Vault Light
Instruction #1025374 Rev A Product #222809
Instructions and Usage
Location of Controls
1. ON/OFF/DIMMER Switch
2. Battery Compartment*
3. Light Sensor Switch
1.
2.
3.
4.
Installation -- Hook and Loop Tape
(included)
1. Check the location of where you want to put the vault light.
Make sure it is clean and free of debris or dust.
2. Put the two pieces of hook and loop tape together so
that the hook and loop sides adhere to each other.
NOTE:
Hook and loop tape may be cut to desired size for easier removal.
3. Remove plastic covering on one side of the tape.
4. Place the tape in the center of vault light base.
This is the battery compartment side.
5. Remove plastic covering on the other side of the tape.
6. Place light in the desired location. Press firmly and hold
for five (5) seconds for to tape adhere to the surface.
7. Make sure light sensor is facing in the direction of
ambient light source for proper operation.
CAUTION:
Be cautious of what surface the hook and loop adhesive is
attached to, as it may remove paint or damage surface.
Screw
(included)
1. Drill a pilot hole in the location where you want to mount the light.
The hole should be where you want the center of light to be located.
2. Put screw (included) in pre-drilled hole. Leave ½” of the screw out of the hole.
3. Slide battery cover over screw. Prongs should face down as shown.
4. Slide battery cover to the left or the right so that the neck of screw is in the narrow part
of the hole. Tighten screw until battery cover is secure to surface. Do not over tighten.
Attach vault light body to battery cover.
5. Make sure the light sensor is facing in the direction of the ambient light source
for proper operation.
4. Light Sensor
*Underneath unit
