Batmatic CR5560, Manual

Page: 14 / 32

CR5560 / CR5570 / CR5585 R02
TROUBLESHOOTING
TROUBLE POSSIBLE CAUSE SOLUTION
Reduced speed or not forward
motion
Low oil level. Check the oil level
in the hydraulic pump located in
the handle
Top the oil until the level. Move
the command lever for several
times (this operation helps
blowing the air out from the oil
circuit)
The machine goes only
backward
The lip packing is broken or
weared
Replace the lip packing
Low backward speed or not
speed at all
There’s too much oil in the
hydraulic pump located on the
handle
Fill out the oil in excess and
restore the level
The pump oil level decreases
during the time
There’s some air under
pressure in the pump
Open the pump’s cap to blow
the exceeding air out
The oil pipe leaks Replace the leaking parts
The engine’s revs are regular
but the machine does not
vibrate
The seal of vibrating cylinder is
broken or weared and spilling
the oil inside the vibrator
Replace the seal and top up the
oil level (pump and exciter)
Replace the belt
The transmission belt is broken
The wear and tear has caused
the belt to loosen up
Replace the centrifugal clutch
The engine’s revs are low but
the exciter does not stop
The centrifugal clutch has
broken
The centrifugal clutch has
broken
Repair or replace the centrifugal
clutch
Repair or replace the centrifugal
clutch
Reduced or irregular speed The engine revs are not correct
Verify that during compaction
gas lever is at the max position
Reset the engine revs with
proper instrument
The engine works and the
exciter makes vibration but the
machine doesn’t work or work
in irregular way
Mechanical failure or dismissing
of eccentrical weight
Open the exciter and remove
the cause of failure
- 14 -