1) Fit the wall fixing brackets to bath timber frames to
allow the bath to be secured to walls that abut the
bath.
2) Drill and affix Taps.
3) Fit wastes, overflow and waste traps supplied.
4) Place bath into position & adjust to minimum
height. The bath is adjusted at its lowest height to
ensure door 'step in' threshold is kept at a
minimum.
Note: It is advisable to fix batten runs on to the
floor under the bath feet to avoid extending the
legs to far & to ensure feet sit squarely and flat. On
a wooden floor batten runs
(minimum 3” x 2”) should be positioned squarely
across the floor boards to spread & support the
load.
5) Level bath in all planes and lock the feet.
6) Mark wall fixings and plumbing runs.
7) Remove bath, drill wall fixings and run plumbing
into position.
8) Re-position bath and affix to wall and to floor.
Ensure the 2 bath feet under the doorway is
cranked up to support the foot well as well as the
doorway integrity.
9) Connect plumbing. The wastes may be run
independently or joined by use of a tee, inserted
after the in line traps. Refer to fitting guides for the
Thermostatic valve and Pump if supplied.
10) Test plumbing for leaks and pump operation.
11) Fill bath to maximum and leave for about 30
minutes to test the door seal.
12) Whilst bath seal is tested position and trim to size
front and side panels if required (front panel lips
into top rim and is pre-cut to bath height).
13) End panel will require batten support along floor
and on the vertical corner sides. Mark bottom of
panels onto floor base and on the vertical and fit
accordingly.
14) Refit front and side panels. Drill through bottom
into batten. Affix panels using screws and caps. Do
not use Silicone sealant as this prevents service
access.
15) Finally drain bath and Leave the Door Open to
prevent over compression and wearing of the seal.
16) Instruct customer on the use of the bath.
2
STANDARD FITTING GUIDE
REFER TO 'OPERATING/CARE AND MAINTENANCE INSTRUCTIONS' AND LEAVE COPY WITH CUSTOMER.
DO NOT LEAVE DOOR IN LOCKED POSITION ON COMPLETION. ADVISE CUSTOMER THAT THE DOOR
SHOULD BE LEFT UNLOCKED WHEN NOT IN USE IN ORDER TO PRESERVE THE SEAL.
April 2014
Made in UK
