27
Display functions
Power On / Off
Confirmation OK
Left Selector
Right Selector
Bluetooth Speaker
Underwater Lighting
Water Pump
Thermostatic Heating
Air Pump
Power On / Off
Press ”Power” button for 2 seconds to turn on the power. This also
turns on the light. Press the button again to turn off the power.
Underwater Lighting
When the power is turned on, press ”Left” or ”Right” buttons until
display shows ”Lighting” icon. Press ”OK” button to turn on the lighting.
Press ”OK” button again to turn off the lighting.
Air pump
Press ”Left” or ”Right” buttons until the ”Air Pump” icon lights up.
Press ”OK” to increase the strength of the pump. The icon in the display
will blink. Press ”OK” 4 times to turn off the pump - icon in the display
will stop flashing.
Water Pump
Water level sensor protects the water
pump from short circuit and prevents
the pump from burning out. If water
level is below the sensor, the water
pump will not operate.
Press ”Left” or ”Right” buttons until the ”Water Pump” icon lights up.
When the water level is above the sensor, press ”OK” to turn on the
water pump.
The intensity of the massage can be
regulated by opening and closing the
air supply by turning the air control
knob clockwise or counterclockwise.
When water pump is turned on, the
system monitors the water level. If the water
level gets lower than the sensor, the pump will automatically turn off.
At the same time, the ”Water Pump” icon starts blinking. When water
level gets above sensor, the icon stops flashing and the pump starts to
work again.
Thermostatic Heating
This function works only when water pump is turned on.
The heating element is designed for keeping the water in the tub at
3
5
-4
5
°C. It is not designed for warming up the cold water to a
bathing temperature.
Press ”Left” or ”Right” buttons until ”Thermostatic Heating” icon lights
up. Press then ”OK” to start the heating function. Press ”OK” again to
stop this function.
The heating function starts and stops depending on water temperature.
The system then keeps the water on desired temperature. If water
temperature is higher than the selected temperature, the system will
stop heating. If water temperature is lower than the selected
temperature, the system will start heating.
Temperature of the Thermostatic Heating can be adjusted between
35°C - 45°C. When the heating mode is on, press ”Power” button until
”°C” in the display starts blinking. Press then ”Left” or ”Right” buttons to
adjust the temperature.
Bluetooth Speaker
When the power is turned on, press ”Left” or ”Right” buttons until
”Bluetooth Speaker” icon lights up. Press ”OK” button to start
Bluetooth function. Display will show ”BT”. Press again ”OK” to turn off
the Bluetooth function.
When the bluetooth speaker is switched on, you can use a mobile phone
or tablet with bluetooth to search for it, then connect to your mobile to
play music. Once your phone is connected to the Bluetooth speaker, you
use your mobile phone to adjust volume, skip to next song etc.
Summary of Contents for 12-130-03-11-00
Page 1: ...13 8 2019 WHIRPOOLS EXCLUSIVE...
Page 6: ...6 O ring 6 7 a b c d 8...
Page 7: ...7 SILIKONE SILIKONE 9 10...
