BaSys FOLDJET 2000, General Operations Manual, Page: 5 / 17

Page 3
User Set-up
You may end the User Set-up menu by pressing the key or continue through the
program again by pressing the up arrow key.
End User Set-up:
By pressing the key the unit of measurement can be changed from inches to
mm.
M e a s u r e m e n t
Units:
This mode enables you to change the edge of the folded material introduced into
the paper guide. In the normal mode the title block is face up as the leading edge
first into the folder with the border edge in the paper guide.
By pressing the
key the mode changes to inverted so that the folded drawing
can be introduced with the border side opposite the paper guide and the title
block face down.
Crossfold norm/inv.:
With the key you can switch the crossfold function on or off.
Crossfold On/Off:
Setting for Crossfold width same as for setting foldwidth 190 mm.
Range: 100 - 350 mm./ 4.1 - 13.75"
Crossfold Width:
The language used on the display panel can be changed between German and English
by pressing the
key.
Language:
Press to change the format type, Press to enter your choice to the menu. The
available Formats are DIN 824, US-Architectural and US-Engineering .
Paper Format:
Setting same as 190 mm. Range: 10 - 50 mm./ 0.4 - 1.96" Margin Change:
Setting same as 190 mm. Range: 100 - 350 mm./ 4.1 - 13.75"
Foldwidth Change
210 mm / 8.25":
With the keys you are able to adjust the foldwidth. The key will set the
desired width to memory. Range: 100 - 330 mm./ 4.1 - 13"
Foldwidth Change
190 mm / 7.5":
Current Software-Version installed in the FOLDJET. Software Version:
This indicates the total number of sheets which have been folded. With the key
you are able to reset the counter to zero.
Sheet Counter:
To enter User Set-up press both the Packetfold and Border keys simultaneously.
By use of the
keys you will be able to move through the menu and
reset the values.