BaSys FOLDJET 2000, General Operations Manual, Page: 4 / 17

Page 2
Feeding Instructions
Positioning of the Paper
-
-
-
-
-
-
-
-
Lay the paper flat on the feed in table.
Smooth out paper and flatten any folded edges.
Make sure the first few inches of the leading edge(15 -20 cm)is not curled. If curl exists re-roll the paper
against the curl to flatten out the paper.
Position the plan face up with the title block in the lower right hand corner as per the diagram on the paper
guide.
Lightly bring the paper into contact with the inside edge of the paper guide, (Note: Do not push too firmly as
this will cause the paper to crease) then with a constant motion move the paper parallel to the paper guide to
the paper guide roller. Make sure the paper remains square and flat upon entry to the folder.
Please note that the leading edge will be on top after the folding is completed.
Do not feed in the next sheet until the folding of the first sheet is completed and the paper has exited to the
paper receiving tray. Also make sure that the next sheet to be folded is not under the sensors in the paper
guide area as this will cause a default message or cause the first sheet to be folded incorrectly.
Once the first sheet has been fanfolded the plan may be re-introduced to the folder to perform the crossfold.
This operation is automatic as the FOLDJET detects the narrow width of the folded paper and goes into the
crossfold mode. Remove the folded plan from the receiving tray and smooth out the fold on the paper feed in
table. Move the plan against the lower edge of the paper guide and with a constant motion move the plan to
the paper guide roller. Please note that the maximum size which can be cross folded isA0/E size format.