www.bassboss.com
©
®
2018 True Lee Loudspeakers, LLC – [email protected] – 512-368-3268 855-8-BASS-70 Toll Free
Page 7
SET UP INSTRUCTIONS
1. Place loudspeaker in the desired location. Ensure that it is secure and stable.
2. Rotate the input attenuator knob counterclockwise to the lowest setting.
3. Connect signal via the XLR input jack.
4. Connect the amplifier module’s power supply cord using the blue PowerCON connectors. To insert, align the indexing tabs on the PowerCON
connector, insert it into the socket and rotate clockwise until the latch catches.
5. Connect the electrical plug to a power source.
6. Select the desired preset via the PGM SEL button.
7. Rotate the input attenuator clockwise to achieve the desired sound level.
System Setup Addendum:
When connecting multiple loudspeakers in a system, signal can be passed through from one powered loudspeaker to another using balanced, shielded XLR
cables. No processing is applied to the signal as it passes through from the input to the output connectors in each loudspeaker. Signal can be routed in
any sequence because each loudspeaker receives a full-range signal and applies the necessary processing in order to operate as part of the overall system.
It is recommended to run signal to the nearest box first and patch to the next nearest box in sequence.
TROUBLESHOOTING
If after following the above instructions for setup you have no output from the loudspeakers, please check the following:
Verify that the green power (PWR) LED is on. If not, check the following:
1. Is the power cord plugged into a live outlet?
2. Is the Neutrik PowerCON connector rotated into the locked position?
If the power LED is on, check the following:
Is the green “signal present” LED (SIG) illuminating? If not:
1. Is the signal cable connected to the input?
2. Is the signal cable connected to an operating output at the other end?
3. Is the signal flowing to the input? Check the integrity of the cable.