4
L62GB BASO Safety Shutoff Device Installation Instructions
5. Disconnect and label the wires from the two wire
terminals and remove the device from the
appliance.
6. Remove the new L62GB cover by loosening the
screw on the front of the device.
Note:
The L62GB may be mounted in any position
by the mounting holes in the back of the case or by
using the universal mounting plate supplied with the
device.
7. Attach the universal mounting plate to the device
when required (see Figure 3). Secure the
mounting plate to the switch case with the sheet
metal screws provided. The mounting plate is not
required for exact replacements.
1
2
4
5
3
Universal
Mounting Plate
BASO
Power Unit
Terminal
Wire Terminals
L62GB-3
Cover
Figure 3: L62GB-3 Mounting
8. Mount the L62GB-3 using the holes in the
universal mounting plate that match the mounting
holes for the device being replaced (see Table 3).
Table 3: Mounting Guide
Switch Being Replaced
Use Holes Numbered
PENN® (BASO) L62EA
1, 2, 3
PENN (BASO) L62GB-1
Plate Not Required
Honeywell® C591A
4, 5
ITT/General A100G653
4, 5
Note:
Remove the L62GB cover for access to Holes 3
and 5.
9. Refer to Steps 5 through 8 in the
Installation
section complete the installation.
10. Perform the
Checkout
procedure before leaving
the installation.
