Installation Procedures
The Raturn system should always be placed on a stable, level surface to ensure proper
functioning. To install the Raturn, follow the instructions below.
1.
Attach the black balance arm vertical support to the base plate using two socket head
screws. Orient the notch on the vertical support to the top and facing to the inside.
2.
Remove the two nuts holding the screws on the underside of the balance arm.
3.
Use a hex key to remove the hex screw on the pivot point of the balance arm. This
will allow you to remove the rearing sensor assembly and expose the screw under-
neath.
WARNING:
The balance arm will disengage from the mount. Be careful not
to drop the arm.
4.
Install the balance arm mount on the support, using the two screws on the arm.
5.
Replace the balance arm and rearing assembly and secure them with the hex screw.
Support the balance arm so that it stays in place during this procedure.
WARNING:
Make sure the balance arm is properly secured with the hex screw before letting go.
CAUTION:
The rearing tab on the balance arm must lie in the notch on the rearing
Section 2. Installation
5
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
