BL-FLOWSTN-P FlowStation Module
Installation Guide
1-866-294-5847
Rev 10.26.2016
ww.baselinesystems.com
Attaching the FlowStation Module
1. Make sure the power cable is untangled and
routed around the top of the module.
2. On the middle of the three attachment
points for the FlowStation module (directly
above the capacitor on the control board),
put a washer on one of the stainless steel
screws, and then partially thread the screw
into the standoff.
3. On the mounting plate attached to the
back of the FlowStation module, find the
V-shaped notch. Align that notch with the
screw that you inserted in step 2.
4. Align the other two holes on the mounting
plate with the upper attachment points and
partially thread a stainless steel screw into
each hole.
Tip
: To put the screws in these hard-to-reach
locations, you might want to use a magnetic
screwdriver.
5. Verify that the screw with the washer is
securely seated in the V-shaped notch on
the mounting plate, and then tighten the
two screws at the top of the FlowStation
module.
6. Attach the FlowStation power cable to
the connector on the right side of the
BaseStation 3200 control board.
7. Tuck the extra power cable length under
the FlowStation module.
