ME9000LH-17/25 EXCELA-WYND
™
HOSE REEL (Patent Pending)
INSTALLATION AND OPERATING INSTRUCTIONS
Form #1176, Excela-Wynd™ Hose Reel IOM
Page | 6
Rev B
12/1/21
Connecting Hose to Offset Riser -
Remove the Offset Riser from the Accessories Box and make the NPT connection using
high quality PTFE sealant / tape and tighten securely.
Note -
To improve level wind performance, align riser with curvature of hose, as shown.
Installing Hose in Gimbal Hose Guide - Using 3/4” wrenches,
remove the nut, bolt and washers holding the gimbal roller,
remove the roller assembly and set aside. Remove the right rear vertical roller post assembly and set aside, being careful
to retain the internal tooth lock washer.
With riser connected to hose, route hose between vertical rollers and inside gimbal fork. Reinstall gimbal roller assembly
and hardware and tighten securely. Reinstall vertical roller post assembly, including lock washer, and tighten securely.
