base engineering FHSTP Series, Installation And Operating Instructions Manual

Page: 6 / 12

April 2012 DSST Installation Guide, Rev. 5 Page 6 of 10
System Programming
The DSST Wireless Control System is supplied from the factory fully programmed and ready for
use, however, the following procedures can be used to re-program a replacement handheld or
receiver unit if the field, as well as modifying minimum and maximum proportional output
speeds.
*NOTE: The user should ensure that there are no other operational handheld units
within range of the system as they could interfere with the dedication process.
Handheld Dedication Procedure.
To dedicate the handheld to the receiver follow the steps described below:
1. Turn the receiver module on. The blue LED on the receiver should be solid (not
flashing).
2. If the E-Stop button is not already pressed, press the E-Stop ON/OFF switch to the OFF
position. Wait 5 seconds.
3. Rapidly release and press the E-Stop ON/OFF button five times in a row. Make sure that
in the last press the E-Stop stays in the OFF position.
4. Wait for the RED LED (Battery indicator) to blink 5 times.
5. Press the green push button located near the grey connector on the receiver 5 times
quickly. The blue LED will flash 5 times. Press the button once more. The blue LED will
flash once, go solid, then flash 8 more times.
6. Once the blue LED on the receiver goes solid, the red LED in the Handheld should blink
6 times to indicated that the procedure was successful. If the handheld blinks only twice,
repeat from step 1.
Programming Instructions For Adjusting Minimum and Maximum Speeds on DSS*P
Systems. (Not applicable to non-proportional systems)
1. Power on the Receiver and wait until initial startup has completed (Blue LED will stop
flashing and go solid).
2. Turn on the handheld by twisting/pulling the Emergency Stop button. If already pulled
but the handheld has shutdown due to timeout, press the Emergency Stop button, wait
at least 1 second, then twist/pull the Emergency Stop button.
3. Proceed to section 4a if adjusting minimum speed. Proceed to section 5a if adjusting
maximum speed.
4. Adjusting minimum speed (lowest attainable system speed):
a. Press the programming button on the receiver quickly 3 times. The blue LED
should blink 3 times in confirmation. If pressed incorrectly, the middle red LED
will blink 4 times. Repeat this step.