Base aire AirWerx 90, Installation & Operation Manual

Page: 12 / 16

10
Troubleshooting
Solution Cause
Symptom
Power Supply
Verify that there is power to the outlet and
that the plug is properly installed in outlet.
Room Temperature Over
105
℉ (Display HI) or Below
33 .8℉ ( Display LO)
The unit id outside the operating
temperature range. Modify the room
conditions so the temperature is between
33.8-10
4℉ and operation will commence
.
Trouble Code: HI or LO
Clean the filter mesh according to
instructions listed in manual
.
Clear the blockage from inlet or outlet.
Air Filter is Clogged
Air Inlet or Outlet is Blocked
.
Machine Won’t Run
Low Air Flow
Trouble Code: E1
Loud Noise
Filter Mesh is Blocked
E1
=
Humidity Sensor Issues
Room Temperature Over
104
℉ or Below33.8 ℉
( Display LO)
Machine Is Not level
Move the dehumidifier to flat, firm ground.
Clean the filter mesh according to
instructions listed in manual.
Check to ensure that wire is connected at
both ends. If no issues are visible, the
sensor may be faulty.
The unit is outside the operating
temperature range
.
Modify the room
conditions so the temperature is between
33.8°
-
10 4℉ and operation will commence
.
If room conditions are within temperature
range
,
replace the defective sensor
.
Flex Duct Installation
Rotate the flex duct counter
-
clockwise
.
Flex Duct Removal
Rotate flex duct clockwise or remove wire tie.