Installation and commissioning
•
Use a standard European back box with screws. The distance between the screws needs to be 60mm. The
required depth is 30mm, although additional depth should be reserved for connecting the device.
For 2-gang Chopin, use a 2-gang European back box with a centre to centre distance of 71mm.
To verify your compatible back box, please refer
to the back box application note on basalte.world.
•
Mount the Chopin with the programming button upwards. Use screws with a countersunk, flat head.
•
Connect the switch to the KNX bus according to the KNX guidelines.
•
Load the physical address into the Chopin switch from ETS via the KNX bus.
•
Commission the Chopin switch using ETS and load the configuration into the device.
•
Please refer to the software manual to configure the Chopin switch.
Do not apply too much force screwing Chopin electronics to the backbox, otherwise you risk the levers to
not function properly.
How to mount the Chopin front cover
(not included)
How to remove the Chopin cover
(not included)
d
Push the cover upwards
e
Tilt the cover away from the wall
d
e
Installation Manual
©
2020
bas
alt
e v1.
0
CHOPIN KNX
a
Place the Chopin front cover over the lower clips
b
Push the Chopin front cover upwards and tilt
towards the wall
c
Attach the Chopin front cover over the top clips
Pushing the cover straight
into the clips without
pushing upwards and lifting
might damage the Chopin
electronics.
a
b
c
1
2
3
4
basalte
bv
| hundelgemsesteenweg 1A | 9820 merelbeke | belgium
t +32 (0)9 385 78 38 | f +32 (0)9 329 66 95 | www.basalte.be | [email protected]
Technical data
Current consumption KNX bus:
10mA
Ambient temperature:
Operation: -5°C to 45°C
Storage: -15°C to 55°C
Transport: -15°C to 55°C
Max. humidity:
93% relative humidity,
no moisture condensation
Protection class:
II
Type of protection:
IP 20
Certification:
CE
