BAS Rodger, User Manual

Page: 3 / 72

3
UK
Installa on bedwe ng alarm
• Place the plug in the receiver.
• Plug the receiver into an electrical outlet and switch it on by pressing the central LED
bu on
(A) , which will light up green.
• The bedwe ng alarm is now ready for use.
• The receiver can also be used with ba eries. Never use ba eries in combina on
with a wall plug.
Pairing a transmi er or a second receiver:
The transmi er and receiver are paired already.
You only have to pair
once the transmi er and receiver if:
1. When you use 2 receivers to 1 transmi er. The extra receiver needs to be paired.
2. When you use a new transmi er with a exis ng receiver.
• Plug the receiver into an electrical outlet and switch it on by pressing the central LED
bu on
(A) , which will light up green.
• Press the – and + bu ons (B + C) simultaneously for 3 seconds.
• The central LED bu on (A) will start blinking green: within 1 minute you have to
connect the two push-bu ons of the transmi er with the metal strip (F) of the
receiver. The transmi er and receiver are paired when the LED lights up green and
the receiver gives a sound.
• The pairing failed when a siren goes o ff a er 1 minute.
Alarm test:
• Make sure that the receiver is switched on and volume is adjusted (+ bu on (C) ).
• Connect the two push-bu ons of the transmi er with the metal strip (F) on the
receiver. This will cause the alarm to sound and the LED (A) will start blinking red.
• The alarm can be turned o ff by pushing the central LED bu on (A) .
Se ng alarm sounds:
| For each alarm to make the same sound:
Select the sound of your choice by pressing the SELECT- bu on (D) . The last selected
sound will be heard every me the alarm goes o ff .
To test the sound, connect the two push-bu ons of the transmi er with the metal
strip
(F) of the receiver. This will cause the alarm to sound and the LED (A) will start
blinking red.