Installation and operation
A162820E
17 / 22
EN
Draining off and removal of frying oil / liquid fat in cube (block)
1. The frying oil / liquid fat in cube (block) should be replaced when it no longer
fulfils legal requirements.
2. The used frying oil / fat in cube (block) should be disposed of according to
provisions of law on environment protection and local regulations in force.
3. After cooling, the frying oil or fat in cube (block) should be drained from the tank
via fat drain tap into a suitable container. Make sure that the container is placed
stably.
4. If the
fat from cubes or blocks
hardens in the fryer, it may only be melted after
rotating the temperature control knob to melting point position; then, the fat
should be drained through fat drain tap into a suitable container. Make sure that
the container is placed stably.
The overheating protection system
If the fryer is accidentally switched on without frying oil or fat in cube (block), or if
the tank is filled with fat to the level below required minimum, the overheating
protection system automatically switches off the appliance. This function serves the
purpose of protecting the appliance against possible damages.
1. Disconnect the appliance from the power supply.
2. Perform the following steps:
– leave the appliance to cool down completely;
– screw off plastic cover over the RESET button on the
rear wall of the control box, rotating it counter-
clockwise;
– press the button;
– screw the plastic cover anew, rotating it clockwise;
– switch on the appliance as usual.
Summary of Contents for SNACK I Plus
Page 1: ... SNACK I Plus A162820E ...
