Bartscher Mini Plus, Instruction Manual

Page: 10 / 13

- 21 -
5.2 Installation and connection
ATTENTION!
Installation and connection of the device should be performed only by a qualified
service center.
Setup
•
Unpack the device and remove all packing material. Carefully remove the protective
film from the outside of the device to avoid leftover glue. If any glue remains stuck to
the device, remove it using an appropriate solvent.
•
Put the device in a safe place that can support its weight and is heat-resistant.
•
Never place the device on a flammable surface.
•
Do not operate the device near an open flame, electric oven, heater or other source
of heat.
•
Do not place the device near walls or other flammable materials. Maintain a minimum
distance of 10 cm from all sides.
•
If the device is to be placed directly next to a wall or furniture, they must be resistant
to temperatures of 60 °C. If the wall's structure c ontains any flammable materials, it
must be protected by a heat-resistant layer.
•
Do not put the device in places with high ambient humidity. Excessive moisture can
damage the device.
•
Do not put the device in moist or wet areas.
•
The device can only be used in a well-ventilated area.
•
Never cover the device's ventilation ducts. Never place towels or cloths on the device,
and never hang any objects on the device.
Connection
•
The socket's circuit must be secured to a minimum of 16A. Only connect the
device directly to a wall socket; do not use extension cords or power strips.
•
The device should be placed to provide quick access in case it becomes necessary
to disconnect it.