Installation and operation
16 / 22
370276
EN
The red indicator light in the push rotary time control knob blinks. When the time
elapses, the acoustic signal is generated. To switch off the signal, press the push
rotary time control knob shortly.
NOTE!
When the set time elapses, the appliance does not switch to standby mode
— the heating element is still active. The timer has no influence onto the
heating function.
The previously set time is displayed again on the digital display and another waffle
may be prepared with the use of the same setting. To this end, press the push
rotary time control knob.
The appliance may also be used without the timer if the push rotary time control
knob is not activated through pushing it.
Baking Waffles
1. Open the heated appliance with the use of the handle and make sure that the
top tray is opened up to the limit.
2. Spread a small amount of vegetable oil on the bottom baking tray (ore spray
with a spray preventing adhesion).
3. Use a ladle, a spoon or batter batching
container to pour the prepared batter
onto the bottom baking tray, starting from
the middle and spreading it uniformly.
ATTENTION!
Pay attention to the amount of batter,
as an excess of batter may spill over
the edges of the appliance.
Fig. 3
4. Close the appliance and use the handle to press the top baking tray down to
spread the batter uniformly.
5. Depending on the required browning level, bake for approx. 1
–2 minutes.
Summary of Contents for MDI Cone 2120
Page 1: ...MDI Cone 2120 370276...