Installation and operation
105864
13 / 22
EN
Flush-Mounted Installation
The appliance and the control unit must be flush-mounted in the worktop
separately. During installation, follow these indications:
1. For installation, select a worktop board that is heat resistant to avoid
deformation due to the heat radiation of the appliance.
2. Make sure that the thickness of the worktop board meets the required load-
bearing capacity.
Silicone Frame Installation
A rubber gasket is delivered with the appliance; it must be glued to the appliance
first, so that the appliance may be installed in an opening, clean and tight. Perform
the following steps:
1. Remove the self-adhesive strip
A
from the silicone frame.
2. Place the silicone frame at the
bottom around the ceramic glass.
Summary of Contents for IW3-EBBF
Page 1: ...IW3 EBBF 105864...
