Installation and operation
16 / 32
104609
EN
3. To reduce the share of humidity in flake ice, press the control key until it
changes its colour to white.
If the control key is not pressed during 5 seconds, the entered setting will be saved
and the appliance will leave the change phase (Fig. 9).
Setting Probe in Storage Container
With time, due to the change in ambient temperature, the set value for temperature
probe in the storage container may appear to be insufficient. To set this value,
proceed the following way:
1. In Standby mode, press the control key 3 times over a 2-second period (Fig. 9).
The control key lights up in white or red.
2. To increase the set temperature, press the control key (Fig. 9) repeatedly and
try to change the key colour to red.
3. To reduce the temperature, press the control key repeatedly until it changes its
colour to white.
If the control key is not pressed during 5 seconds, the entered setting will be saved
and the appliance will leave the change phase (Fig. 9).
Malfunctions
ATTENTION!
In the case of incorrect operation, disconnect the appliance from power
and water supply. Contact an authorised service, check the appliance and
have it repaired.
• Check if the water supply tap is open.
• Check if the appliance is powered electrically: if the plug is properly connected,
and the disconnecting device is switched on.
• Make sure there are no strange vibrations generated by loose screws.
• If you must perform tasks connected with water loss, screw tightening, etc.,
always switch the appliance off first, and check whether clogged drains are not
the reason for leaks.
• If the appliance produces too little ice, check the condenser for cleanliness and
the coolant for leaks.
• Check the storage container probe for operation: place an ice cube on a cooled
probe inside the storage container; the appliance (Fig. 14) should stop within 1
minute and automatically re-start shortly after the ice cube is removed.
