Bartscher Coffeeline 190.161, Instruction Manual

Page: 41 / 113

- 37 -
Now press the “Continuous function button” once, for less than 1 second. Hot water will
flow out of the hot water spout. After the required amount of water is received, press the
button again and the water portion for tea is set. The water portion for tea can also be
set for every brewing assembly.
Coffee doses programming
Press and hold the „continuous function button“ from the left brewing assembly for longer
than 8 seconds. The program’s current setting is displayed on the LED display of a given
brewing assembly (besides the LED „continuous function button“- it flashes). The display
shows the following information:
Now press the button which is to be programmed (1 x espresso – 1 x coffee –
2 x espresso – 2 x coffee). All LED displays (including the one chosen and „continuous
function button“) go out. Coffee will begin to flow. When the required amount of coffee is
received, press the button again - the dose is now set and the LED light over the button
will go out.
The new process is programmed as a new coffee dose. As necessary the process can
be repeated for other dose buttons to set the required portions.
NOTE!
If one of the portion buttons on the left service panel (as seen from the front)
is
reset, the dose will be set for the appropriate buttons of the following
brewing assemblies.
Example: Let us change the dose for the button labelled “1 x espresso”. This dose will
be programmed and remembered for all “1 x espresso” buttons on the service
panel.
As stated above, this is only possible for changes made on the left service
panel. If changes are set via other service panels, they will affect only the
one button.
NOTE!
New programmes should be set with fresh coffee in the filter basket.
Doses programming
select 30s