- 52 -
Before starting operations remove the protective film from the appliance. Remove the
film slowly in order not to leave the glue residues. Any glue residues may be removed
with use of a suitable solvent.
CAUTION!
Never remove the rating plate or any warning signs from the appliance.
5.1.3 Stabilizer
NOTE!
To avoid tilting of the device forward, install the rear stabilizer. The required
angles, dowels and screws are supplied.
The oven protection wall is located at the
rear of the device. Carefully measure the H
distance to the highest point of the
protection wall from the floor
(A)
.
Fig. 4
Use the measured H value to mark the drill
holes for dowels on the wall at which the
device will be installed
(B)
.
Fig. 5
Furthermore, mark on the wall the
centre of the gas stove at the same
height as the previously measured H
value
(C)
.
Drill the holes in the wall.
Fig. 6
