- 28 -
•
The installation surface must be well accessible and sufficiently large. To enable
comfortable use of the device and to provide good air circulation on all sides, keep
the least distance of 20 cm to all sides of the appliance and 50 cm above and in
front of it.
•
Set up the appliance device in such manner that the plug is accessible, so that the
appliance can be quickly disconnected from the power network if necessary.
Connection
DANGER! Electric shock hazard!
The device can cause injuries due to improper installation!
Before installation and connecting the local power grid specification should
be compared with that of the device (see rating plate). Connect the device only
in case of compliance!
Connect the device only to properly installed single socket with
protective terminal.
•
The electrical circuit in the socket must be secured to at least 16A. Only connect the
device directly to the wall socket; do not use any extension cords or power strips.
5.2 Operation
Preparing the device
•
Clean the appliance before first use according to instructions in Section 6 „Cleaning“.
•
Insert the fat collecting cap.
•
Connect the device to a grounded single socket . The green operating light ON /OFF
lights up and indicates that the device is connected to the power supply.
•
Heat the device without food up to 200 °C (Section „Grilling of food“) in order to
possibly remove production residues. During the first heating a light smoke formation
can occur, because of inside industrial fats escape. This smoke is not harmful
and it does not occur no longer during the further use of the device.
Provide enough fresh air supply during heating.
