- 40 -
Change of required value (required temperature)
press and hold button
for at least 3 seconds;
the required value will be displayed and the diode
or
will flash on the display;
use button
or
to decrease or increase the value until the display shows
the required value;
confirm new value with button
or wait 10 seconds for the automatic storing
of set value.
NOTE!
Other settings and changes of parameters can be found in the
accompanying description of the digital temperature controller and
should be set by specialist staff.
Switching off the device
If a break is expected in using the device, turn it off using the main switch (position
"O"
(OFF)
) and disconnect from the power supply (pull out the plug!).
NOTE!
Any water accumulated in the bottom of the device can be removed by the
discharge pipe below the device.
Defrosting
Automatic defrosting
The device is automatically defrosted four times within 24 hours. The clock starts
upon first activation. If the automatic defrosting is to be carried out at other times,
press
for more than 2 seconds. The digital display shows
„
”
.
Defrosting will start right away, the next defrosting will take place after 6 hours.
Defrosting manually
In addition to automatic defrosting, manually defrosting can be activated at any time,
to do this, hold down the
for more than 2 seconds.
Manual defrosting commences. The digital display shows
„
”
.
NOTE!
Condensation water evaporates automatically.
