Installation and operation
271107
13 / 22
EN
1. Using information provided in the figure, mark points on the wall for boreholes.
2. Bore the holes.
3. Insert the studs into the bored holes.
4. Screw the appropriate number of installation brackets to the wall.
5. Hang the extractor hood on the installation brackets.
Fig. 3
Ceiling Installing of Extractor Hoods
Check Fig. 4 to see how to safeguard the product for the purpose of additional
stabilization.
NOTE!
In the case of 700 mm extractor hoods ceiling mounting is not required.
Execute only wall mounting with the use of brackets.
1. For each fixing holder use M5 bolt, as presented in the figure (detail B).
2. Screw the enclosed eye bolts directly into the pre-prepared openings at the top
edge of the extractor hood.
3. Anchor the front section of the extractor hood in the ceiling, using chains or
cords (not in the set) and eye bolts (detail C).
