Installation and operation
12 / 18
150175
EN
Power supply connection
• Verify if technical data of the appliance (see rating plate) correspond with the
local electric power grid specification.
• Connect the appliance to a single, properly grounded mains socket with
protective contact. Do not connect the appliance to a multi-socket.
• The power cord should be laid in a way preventing anyone from threading on it
or tripping against it.
• Do not use the appliance with an external timer or remote control.
5.2
Operation
WARNING!
Injury hazard!
The blade at the bottom of the mixing beaker is very sharp!
Do not reach into the mixing beaker.
Hot surface!
Moving elements become hot during prolonged use!
Do not touch moving elements.
Risk of scalding by escaping vapour and spatters!
Hot dishes should be prepared only with the lowest speed and with the lid
and the lid closing tightly fitted.
Preparation of the Appliance
1. Prior to first use, thoroughly clean the appliance and equipment according to
instructions in section
6 'Cleaning'
.
2. All washed parts should be dried thoroughly.
3. Set the motor block on an even surface and make sure it stands stably on the
surface.
4. Insert the mixing beaker onto the positioning handles on the motor block. Pay
attention, so that mixing beaker handle is at the right.
NOTE: For safety reasons, the appliance is equipped with a safety switch,
which makes it possible to operate the appliance only with the container
correctly set and the lid closed.
Appliance Start-Up
Summary of Contents for 150175
Page 1: ...2 6L 150175 ...
