Bartscher 104523, Manual

Page: 23 / 35

Installation and operation
104523 17 / 35
EN
4. Connect the other end of the tube to the water connection at the back of the
appliance.
NOTE!
Due to practical and safety reasons we suggest to integrate a shut-off
valve, which is not a part of the delivery (Fig. 7):
1. ON/OFF switch; 2. Socket; 3. Plug; 4. Water connection; 5. Shut-off valve;
6. Water drain from condenser: water cooling version;
7. Water drain from storage container; 8. Water drain to open water trap.
Water Drain
1. Connect the enclosed water drain tube to the drain connection at the rear of the
appliance.
2. The other end of the water drain tube introduce into the open water trap (Fig. 7).
NOTE!
To provide for perfect water drain, the water drain tube must be routed at
the inclination of at least 3%; at the same time make sure it is not tangled
nor bent.
Power supply connection
• Verify if technical data of the appliance (see rating plate) correspond with the
local electric power grid specification.
• Connect the appliance to a single, properly grounded mains socket with
protective contact. Do not connect the appliance to a multi-socket.
• The power cord should be laid in a way preventing anyone from threading on it
or tripping against it.
• The maximum allowable tolerance for voltage difference is ±10% of rated value.
• The electric circuit between the appliance and the power supply connection
should be equipped with a suitable multi-polar disconnecting device (Fig. 7),
which is capable of providing distance of contact opening rendering full
separation possible in the conditions of overvoltage category III.
• If in winter the appliance is brought from the outside to a room, leave it for a few
hours to heat up and reach the room temperature before switching it on.
• Before connecting the appliance to the power supply, wait 1 hour for the coolant
to stabilize.
• After a power failure or when the plug is removed from the socket, reconnect the
appliance to the power supply after 5 minutes at the earliest.