![background image](http://html1.mh-extra.com/html/bartell/innovatech-terminator-infinity-2-0/innovatech-terminator-infinity-2-0_manual_3963725012.webp)
P a g e
|
12
OIPB-I01029-Infinity2.0_v1.2
1. To remove the Terminator
®
from a crate with a forklift:
1. Forklift slots have been provided on the sides of the Terminator
®
for moving the
terminator with a forklift.
2. To remove the Terminator
®
from a crate without a forklift:
1.
Take 2 x 4’s off the edge of the crate and between the wheels.
2.
Place 2 x 4’s behind the crate of the rear of the machine.
3.
Make a ramp with the 2 x 4’s and the crate material.
4. To enable power to the Terminator
®
, turn the key, and twist to release the red knob.
5. Pull back the left and right handles evenly and depress the foot pedal slowly. The
machine will start moving slowly backwards.
6. Ensure that both rear wheels come off the crate evenly. Failure to back off evenly
could result in the machine tipping over and harm to the operator.
7. As the machine moves back, ensure that the center wheel clears the crate. If the
center wheel does not clear the crate, raise the machine until the wheel clears.
8. Once the machine is on the ramp, slide it all the way to the bottom, then raise the
jaw up and set the center wheel down on the ground.
9. Whenever mounting or dismounting the Terminator
®
, ALWAYS disable the power by
pressing down on the red power knob.
12. Loading/Unloading Procedures
• Do not load or unload the Terminator
®
on uneven ground.
• Ensure ramps into moving vehicles are stable and square to the ground.
• Always turn off the Terminator
®
before transporting it.
• Load and unload the machine with a properly weighted forklift or lift-gate.
• Make sure all safety stops are installed on a lift-gate before loading or unloading.
• Never position yourself under/around the machine while moving it with other machinery.
• Park the machine with the jaw completely down after loading.
• Properly secure the machine with chains, tire chocks, and other necessary tie downs.
• Never ride in a moving vehicle next to a Terminator
®
. It may tip, causing severe injury.
13. Operator Controls
1. Drive/Jaw Controls
The drive and jaw controls (three levers) are located to the left and right of the operator
seat. The drive levers (left and right) control the direction of rotation of the rear wheels.
The jaw height lever (left) controls the vertical position of the jaw assembly.
•
Push the left and right levers forward
together
, slowly at first, to move the machine
forward.
•
Pull the left and right levers back
together
, slowly at first, and hold them in position to
move the machine in reverse.
•
Push only the left lever forward to turn the machine to the right.
•
Push only the right lever forward to turn the machine to the left.