P a g e
|
9
OIPB-I03026-T2200PRO_v3.1
4. General Operating Instructions for the Terminator
®
The Terminator
®
is designed to remove carpet, tile and glue residue from floors.
• When removing product, position removed product so it rolls to the side of the machine or
have someone on the side of the machine remove the product. NEVER WALK IN FRONT
OF OR BEHIND THE TERMINATOR
®
WHILE IT IS RUNNING.
• Sharpen blades or dice material into narrower widths if machine slows down or seems to
be struggling.
• Do not use the Terminator
®
within one foot of walls or stationary objects. Damage to
objects may occur if the Terminator
®
strikes them.
• Use safe, OSHA-approved tools and methods for sharpening blades.
• Make sure the Terminator
®
has a charged fire extinguisher, working backup alarm, and
strobe light before operating.
5. Safety Features
The Terminator
®
is equipped with several features to help ensure your safety and the
safety of workers around you.
1. Auto Stop
The Terminator
®
has two drive levers located to the right and left of the operator seat
and a jaw height lever to the left of the operator seat. The drive levers control the
forward, reverse, left, and right directions of the machine; the jaw height lever raises
and lowers the jaw assembly. You must push (forward) or pull (reverse) and hold the
levers in position to drive the machine or move the jaw assembly in the direction
desired. When you release a lever, the Terminator
®
or jaw automatically STOPS and
will not move again until you push/pull and hold the levers again. However, these levers
are not meant as brakes. Block wheels with a floor block when stopping on a ramp and
use the emergency brake. Without the emergency brake the machine may roll forward
or backwards on any sloping surface.
2. Warning Light and Back-Up Alarm
An amber light is installed on the top section of the rear battery box. When the ignition is
in the ON position, the warning light will flash. When the drive control is set in
REVERSE, the back-up alarm will sound.
3. Fire Extinguisher
A fire extinguisher with gauge is installed on the hood behind the operator’s seat within
the operator’s reach. As a safety measure, regularly inspect the gauge and recharge the
fire extinguisher as needed to maintain full capacity. Always recharge the extinguisher
after each use.
4. Emergency Battery Disconnect
Under the hood at the front of the engine is a battery disconnect that will remove power
from the motor and other electrical components. WARNING: Removing power from the
Terminator
®
while on a ramp or hill can lead to a dangerous rollaway situation. Always
engage the hand brake before disconnecting power.
Discount-Equipment.com
Summary of Contents for Innovatech Terminator T-2200PRO
Page 26: ...P a g e 25 OIPB I03026 T2200PRO_v3 1 D i s c o u n t E q u i p m e n t c o m...
Page 30: ...P a g e 29 OIPB I03026 T2200PRO_v3 1 D i s c o u n t E q u i p m e n t c o m...
Page 34: ...P a g e 33 OIPB I03026 T2200PRO_v3 1 D i s c o u n t E q u i p m e n t c o m...
Page 36: ...P a g e 35 OIPB I03026 T2200PRO_v3 1 D i s c o u n t E q u i p m e n t c o m...
