Operation
POLARIS PROFESSIONAL
POLARIS II Panel PC
32/45
Technical data subject to change without notice.
04/2018
After the reboot the device is protected again.
Important:
1)
To install a windows update, update a virus data bank and for changing other
settings the UWF must be switched off. It can also cause problems if an
applications package want to be saved on disk drive C:. In the worst case the
RAM-Overlay (buffer of the changes of disk drive C:) can overrun which hinders
the implementation of the applications.
2)
Ist he UWF not activated switching off can lead to destruction of parts of the
operating system up to the impossibility of another starting of the device.
8.1.2
Windows 7 Ultimate
By first introduction the operating system must be installed for the user, please follow the
instructions on the screen.
The Windows 7 Ultimate operating systems do not support EWF!
8.2
Onboard Bartec Recovery Solution
8.2.1
Bartec Recovery Solution
The Bartec HMI Polaris Smart devices are equipped with an On-Board-Recovery solution.
The Bartec Recovery is a software package preloaded on the devices which serves the
disregard of the device in the work state. In case of a mistake every device can be booted
up in the Recovery mode to move afterwards the operating system into the work state.
No other software is necessary for the restoration. The Recovery service already disposes
of all necessary program routines or the Recovery-Wizard to play in the operating system
anew. The process can be carried out any time if necessary also on site. The duration of
the process amounts approx. 25 minutes.
8.2.2
Start of the device in the Recovery mode
To change in the Recovery mode, one must press the F6 key while booting up the device.
This possibility is available for approx. 10 sec. During this time the announcement "
Press
F6 key to start Bartec Recovery"
appears on the screen.
