Operational Instruction
(Translation)
Switch module
Type 07-3323-1.00
BARTEC
GmbH Max-Eyth-Straße 16
97980 Bad Mergentheim
Germany
Tel.: +49 7931 597-0
Fax: +49 7931 597-119
[email protected]
www.bartec.de
Reservation Technical data subject to change without notice. Changes, errors and
misprints may not be used as a basis for any claim for damages.
EN 3/4
01
-3
32
3-
7D
00
01
/B
-0
2/
13
-S
T
V
T
-2
92
80
7
Maintenance and Fault Clearance
Risk of serious injury due to incorrect
proceedings.
Only authorized qualified personnel may
do any of the work relating to maintenance
and fault clearance.
IEC/EN 60079-17 must be observed.
The operator of the switch module must keep it
in good condition, operate it properly, monitor it
and clean it regularly.
Maintenance
Risk of serious accidents due to damaged
parts.
Check switch modules, actuating elements,
actuators, sealings, and cables regularly
for cracks and damage. Make sure that
they are properly established.
Switch module/ actuating element damage
due to incorrect cleaning.
It is not allowed to clean switch modules/
actuating elements with compressed air.
Fault Clearance
Risk of serious injury due to use of non-
original spare parts.
Use original parts only as replacements.
The switch module is defective if the switching
unit does not perform switching functions any
longer.
Defective switch modules cannot be repaired;
they must be replaced considering this opera-
tional instruction.
Defective actuating elements can be removed
from the switch module and replaced by func-
tioning actuating elements of the same type.
Accessories, Spare Parts
See BARTEC catalogue.
Disposal
The components in the switch module and the
actuator contain metal and plastic parts.
Therefore the statutory requirements for dis-
posing of electronic scrap must be observed
(e.g. disposal by an approved disposal com-
pany).
Service Address
BARTEC GmbH
Max-Eyth-Straße 16
97980 Bad Mergentheim
Germany
Tel.:
+49 7931 597-0
Fax:
+49 7931 597-119
Installation dimensions
Damage to elements due to incorrect instal-
lation dimensions.
The minimum spacing between the mount-
ing holes must be observed.
Dimensions:
mm
in
A*
70
2.8
B
16.5
0.7
C
Ø
30.3
+0.3
Ø
1.2
+0.01
D
3
0.1
E*
40
1.6
*Recommended spacing for mushroom push-
button, slam button, and: position selector
switches with protective shroud: 100 mm
(3.9 in).
Dimensions in mm (in)
