12
13
If you want to choose the target range from MAX to MIN, you need to press DISC/
NOTCH first and press + or – keys to adjust the range. The cursor bars under target
range will show which metal objectives you may eliminate or select. The detector
can detect the metal type indicated on the display. At meanwhile, the detector rejects
other metal types without displaying on the screen. For example, press + key, 7
levels on cursor bars from Max to Min are increased. At this time, the detector can
detect Pull Tub, S- CAPS, 1¢ and also 25¢, other types of metal are rejected.
Note:
25¢ is unable to be eliminated since it contains silver and may be valuable object.
c. NOTCH—to ignore the metal type you do not want. You can select the metal type
desired by pressing the + and - keys. The LCD cursor bars will indicate the
selected types of metal. The detector can detect the selected metal type.
3. Search Coil Sweeping Hints
• Never sweep the search coil as if it were a pendulum. Raising the search coil while
sweeping or at the end of a sweep will cause false readings.
• Sweep slowly hurrying will cause you to miss targets.
• It is better you sweep the search coil from side to side in an arc line of 3 inches
motion and keep the search coil parallel with the ground.
If the detector detects the item, it sounds a tone, an arrow and the depth
appear on the display below the target icon.
If the detector does not detect the item, make sure that the target mode is set
correctly for the type of metal you’re searching for. Make sure that you’re
moving the search coil correctly.
Notes:
• The detector responds with a signal when it detects most valuable metal
objects. If a signal does not repeat after you sweep the search coil over the target a
few times, the target is probably junk metal.
• False signals can be caused by trashy ground, electrical interference, or large
irregular piece of junk metal.
• False signals are usually broken or non-repeatable.
