
6
7
2. Unscrew the knobs on the search coil (4) and remove the knob and the bolt. Insert
the lower stem (2) and align the holes on the search coil bracket and the stem.
Push the bolt through the holes, and then replace and tighten the knob.
3. Loosen the Top stem’s (1) lock nut in the direction of the arrow. Then insert the
lower stem (2) into the top stem connected with the handle. Turn the stem’s lock
nut in the reverse direction of the arrow to lock it in place.
4. Wind the cable around the stem. Insert the search coil cable plug into the five pin
jack on the front control box’s housing.
5. When you stand upright with the detector in your hand, the search coil is level with
and about .5~2 inches / 1~5cm above the ground. You can lengthen or shorten
the stem basing on your height. After figuring out the suitable length, then tighten
the lock nut.
Caution:
• The search coil cable plug fits into the connector only one way.
• DO NOT force the plug or you could damage it.
• DO NOT disassemble the stem lock nut.
ADJUSTING THE SEARCH COIL
Loosen the knobs at the search coil’s end; adjust the search coil to the desired angle.
(The search coil should be parallel with the ground.) Tighten the knobs just enough
to keep the search coil from rotating or wobbling.
INSTALLING BATTERY
You need two 9V alkaline batteries to power your detector.
1. If the detector is on, turn the power switch (on the control panel) to POWER OFF.
2. Press on the battery compartment cover and slide the cover off in the direction of
the arrow.
3. Connect the battery with the battery connector taking care of the polarity. Then put
the battery into the compartment.
4. Replace the cover.
Cautions:
• Use only fresh batteries of the required size and recommended type.
• Always remove old or weak batteries; batteries can leak chemicals that can destroy
electronic parts.
• If you do not plan to use the detector for a long time, remove the batteries.
• Dispose of old batteries promptly and properly.
• You can extend battery life by using earphones, which require less power than the
built-in speakers.