RDG603A9 - Issue 1 - Shire 14 Workboat Owners Manual 30, 40, 50
Page 7 of 40
SECTION 1 - Safety Precautions
1. General
It is the responsibility of the installer/operator to ensure that the finished installation
complies with the relevant health & safety requirements and the recreational craft
directive before commissioning.
Ensure that the engine battery isolator switch is in the off position and the key removed
from the control panel before carrying out any maintenance or repairs.
2. Lifting
The lifting points supplied with the engine are for lifting the engine/gearbox only. A
suitable spreader bar must be employed to prevent over-stressing either bracket during
any lift
.
3. Rotating Shafts and Belts
The engine and its accessories are not to be put into operation until they are integrated
into the boat as a whole. No person should be in the engine compartment and the engine
cover or deck hatches should be closed whilst the engine is running.
4. Exhaust System
Exhaust gases may have temperatures as high as 600
o
C and contain elements which
are harmful if ingested.
It is therefore essential that exhaust systems are gas tight and lagged to prevent
accidental burning.
5. Launching and Lifting Boats
Care must be taken when launching or craning new boats into or out of the waterway, so
that water does not enter the engine via the exhaust system or air vents. It is
recommended that these are blocked temporarily whilst undertaking this procedure.
