INSTALLATION INSTRUCTIONS
800.533.3948 • www.barronltg.com
1
40070017 REV 1 01/2019
The specialtyLED Distributor packs are made up of an extremely small profile product made up of Light Emitting
Diodes (LED) mounted on a thin flexible copper strip. Due to the construction of the product, special care needs to
be taken during the installation process in order to avoid damaging the LEDs or any of the resistors.
INSTALLATION INSTRUCTIONS
SAFETY PRECAUTIONS:
• Do not bend to the side, product is only bendable front to back.
• Do not cover the product with insulation, paint, caulk or any substance not approved by the manufacturer.
• Do not apply power when tightly coiled.
• Maintain half inch spacing between parts.
• Do not puncture, cut, shorten or splice outside of the designated cutting marks.
• Do not route through walls, doors, windows or building structures.
• Do not mount inside cabinets, tanks or enclosures unless properly ventilated.
• Do not unroll with tape facing down on a rough surface or over sharp corners. This will scratch or
damage the LEDs.
• When unrolling or installing do not twist, pull or kink the product.
• Do not secure with staples, nails or like means that can damage the tape.
• Do not install in locations where it is subject to continuous flexing.
• Do not submerge in liquid or apply near standing water.
• Do not operate in temperatures exceeding 30°C (86°F).
• Do not operate on circuits that do not have proper surge suppression protection. High voltage spikes will
damage the LEDs.
• Do not operate over specified voltage, LED life degradation will be greatly increased.
SAVE THESE INSTRUCTIONS!
READ CAREFULLY AND FOLLOW ALL INSTRUCTIONS FOR YOUR OWN SAFETY
• DISCONNECT AC POWER SUPPLY BEFORE SERVICING.
• Installation and servicing of this equipment should be performed by qualified service personnel only.
• Ensure the electricity connections conform to the National Electrical Code and local regulations if applicable.
• Do not mount near gas or electrical heaters.
• Equipment should be mounted in locations and at heights where it will not readily be subjected to tampering by
unauthorized personnel.
• The use of accessory equipment not recommended by the manufacturer may cause an unsafe condition.
• Any modification or use of non-original components will void the warranty and product liability.
• Do not use this equipment for other than intended use.
FTK
